-
Locate the leak before filling
The refrigerant circulates in a closed circuit and is not consumed during use. Before recharging the system, we locate the source of the leak.
-
Repairs the source of the refrigerant leak
Poorly tightened connection, damaged pipework, brazed joint or worn valve. The underlying fault is repaired, and only then the system is recharged.
-
Restores the measured charge by weight
The correct quantity comes from the unit nameplate and is measured by weight. Too much refrigerant affects performance just as much as too little.
-
Test pressure and let it run
High and low pressures checked, temperatures checked with the unit working. The job is complete only when the unit performs as it should.
We work in your home and your business.
Retail premisesWindow in the sun and open door, without noise at the point of sale.
RestaurantsConsistent comfort at every table, without intrusive noise.
Cafés and bakeriesShowcase and machine heating, with the door always open.
OfficesThe heat comes from people and screens. Leave without hearing yourself.
Hotels and hostelsEach room at the guest's level, without closing off the house.
Short-term rentalsSized by room, to whoever hands over the key.
Clinics and consulting roomsWork without getting into the consultation conversation.
Hairdressers and salonsCool and remove air, with the dryers on.
GymsHeat and humidity from those who train. The air is also renewed.
Warehouses and industrial spacesHigh ceilings, gates that open and heat that rises.
refrigerant recharge: because they trust us.
-
Transparency
Transparency in every recommendation, from first contact to the quote.
-
Professionalism
Technical knowledge and care in the work.
-
Dedication
Commitment to every project, from start to finish.
«During the installation, the entire staff was very careful and attentive. I highly recommend it.”
- Free on-site assessment and quote.
- We serve homes, retail premises and businesses.
- Over 15 years of completed work.
- We serve all mainland Portugal.
We sell, install and maintain the main brands.
How we work.
-
Diagnosis and search for leak
We go to the location, measure the pressures and look for where the refrigerant is coming out. You leave with the fixed price, in writing, before we move.
-
Correction and load
We correct the leak point, create a vacuum in the circuit and replace the refrigerant on the scale, in the quantity indicated on the unit plate.
-
Testing and delivery
Pressures and temperatures measured when the unit is working. We only finish once it is cooling as it should.
Questions we are often asked.
Because it is leaking. refrigerant is not consumed with use — if the level has dropped, there is an outlet somewhere. Filling it up without taking care of it only solves it for a few weeks and then it goes back to the same thing.
Enough to cool down again for a while. But the refrigerant comes out through the same place and you will have to pay for the refill again. That's why we look for the escape first.
It depends on the refrigerant that the unit takes, the quantity and what the leak requires you to do. We'll tell you the price after you see it, and before you move.
No. R22 has been banned in the European Union since 2015, even when recycled, and there is no legal way to replace it. In these cases, the solution is to replace the equipment, and we tell you that frankly instead of beating around the bush.
No. Anyone who intervenes in the refrigerant circuit must be a certified technician — this is article 9, no. 1 of Decree-Law no. 145/2017, and applies to any unit, at home or in a commercial space.
Yes. We handle equipment of any brand, even if we didn't install it ourselves.
Which service do you need?
We reply here with the support of artificial intelligence. This is not a quote: the team confirms everything during the no-obligation visit.
We also deal with:
To read first:
Where we work:
refrigerant refilling and leak detection, municipality by municipality: